SwedeTech Honda CR80 / CR125 Engine Mount - Shifter Kart Use

Description

Please NOTE:
When Ordering, you must send us a note within the order or through messages to specify
Clamps - Dual or Single Bolt
Frame Rail Diameter -
Frame Rail Spacing -
If you are not sure, either contact our chassis supplier or search YouTube for "SwedeTech, How to Measure Frame Rails"
Finally a mount that is made correctly for your Honda CR125 shifter kart engine.
The SwedeTech CR125 Engine mount offers the following features.
Anodized 6061 T6 Aluminum Alloy Engine mount
Chassis clamps designed for either 1 bolt or 2 bolt per clamp option
Adjust the engine from left to right for proper clearance ( approximately 8mm, left to right )
Engine Mount sits the rear of the engine up to 1" lower than other mounts
Hardware securing engine to the mount is the proper sizes to match the Honda Cases
Proper machining from front to back, engine will not be twisted when mounted to a straight frame.
Proper radius on frame contact point
Left side of rear engine mount machined to allow for chassis cross tubing weld clearance
Lightening Holes through out the mount
Stress Points taken into consideration during the design and machining process
Complete assembly weighs 2.75 lbs
This mount may cost a little more than some of the other mounts on the market. Buy the right mount the first time. Save money in the long run.
This is only a reference, for some chassis below.
Contact your chassis Supplier for proper frame rail sizes.
Below is a reference only
CRG, GP, Zanardi, Maranello - 3290
Birel - 3292 or 3092
TonyKart, Kosmic, FA - 3092 or 3292
Intrepid, Praga, OK1 - 3092 or 3292
Q: What do the above numbers mean?
A: 30 or 32 is the Diameter of the engine frame rails. 90 or 92 is the Center to Center Spacing of the engine frame rails. Every model is unique, please measure before ordering.
You can view Youtube videos on engine mounting by searching YouTube for "SwedeTech, Engine Mount, Install"