rusEFI microRusEFI assembled ECU development module

Description

WARNING: AT THIS PRICE POINT YOU BUY ONLY HARDWARE. No TUNING or even SETUP support is included - please read rusEFI wiki and please post all your questions on rusEFI forum
This is a development board that could run a car, with the right software.  If you are looking for a finished ECU to run your engine, this is not what you should be buying.  If you want to get your hands dirty with engine management, this is arguably one of the most capable pieces of hardware to help you do so.  If you buy this, you should be prepared to follow rusEFI development carefully (or write your own ECU software) and be interested in tinkering.  This is not a finished product and if you require a finished product to run your engine, look elsewhere.
For direct technical support see
https://www.ebay.com/itm/333612090037
rusEfi do-it-yourself ECU
perfectly suited for 1, 2, 3 and 4 cylinder applications!
Assembled ECU
: everything inside the case + pigtail or connector kit. Please specify VR or Hall crank position sensor. No soldering - you just hook up wires to the pigtail.
OFF ROAD USE NOTICE: items sold through rusEFI LLC including tuning products may be designed for off-road/race use only, and are not applicable for vehicles in states that require pollution controlled vehicles. California (CARB) & other states prohibit the sale or use of some aftermarket parts, including those that tamper with, modify or defeat emissions systems in any 1966 and newer vehicles. rusEFI LLC prohibits the use of these products on emission controlled vehicles. These parts are sold for OFF ROAD, RACE-ONLY, ground-vehicle use only in a controlled environment.
rusEFI LLC does not implicitly or explicitly confirm the legality of using any products it sells on public roads. Customers are solely responsible for ensuring all products purchased are used in a legal manner.
Primary VR or Hall input (configurable with few resistor changes)
Secondary Hall input
x4 analog thermistor (temperature) inputs
x10 analog voltage inputs (0-5v)
x4 high-Z injector outputs
x2 high-current low side outputs for IAC/VVT/other solenoids
Dedicated main relay control output
x4 low-current low side outputs for relays or warning lights
x4 5v logic-level ignition outputs
x2 5v/12v configurable logic level outputs (requires resistor changes)
Electronic throttle body (drive by wire)
CAN connectivity on the plug
USB connectivity on the plug
google "github microrusefi" for documentation
spare case+pigtail see
https://www.ebay.com/itm/48-pin-harness-case-microRusEfi/333321806659